marchudson
Well Known Member
Was wondering if anyone else ran into this issue? For reference, I'm on page 9-24 of the build manual. Step 9 says Secure the Trim Tab Pushrod to the ES-MSTS-T3-12A Trim Servo as shown in Figure 4. This consists of the pin with two washers the trim tab and a cotter key. There doesn't seem to be enough room to insert the cotter key. Before I go and remove some material from either the trim tab pushrod or the trim servo, I figure that asking the rest of the group what they did in this situation would be helpful. See the attached picture.
Never mind a lot has happened since last night, two fresh cups of coffee this morning
. I grabbed the wrong pin by mistake out of the supply drawer.
![IMG_8183.jpg](/proxy.php?image=https%3A%2F%2Fmarchudson.com%2Fwp-content%2Fuploads%2F2021%2F03%2FIMG_8183.jpg&hash=ca0feea2ba58fafdc05e77d3288df7b2)
Never mind a lot has happened since last night, two fresh cups of coffee this morning
Last edited by a moderator: