I am working on page 11-10 of the empennage plans when you run the trim servo to the full retracted and back to check range of motion of the whole set up
The problem. How Do you actuate the servo? It is not hooked up to power but it does not move free or at all by gently pushing or pulling on the bell crank... I don't want to break it. It certainly is secure in its "from the box" position......
Thanks in advance
Joe B
The problem. How Do you actuate the servo? It is not hooked up to power but it does not move free or at all by gently pushing or pulling on the bell crank... I don't want to break it. It certainly is secure in its "from the box" position......
Thanks in advance
Joe B