lucaperazzolli
Well Known Member
In order to understand some process, I need help with some questions, I'm sure you can give me good ideas of I have to proceed.
I'm sure you think that some are dummy questions but I'm surfing into a little bit confusion...thanks for patience.
My is a Rv8, bus bar with avionic master, circuit breakers, sky-tec starter
- I like to put a CB between ACS starter block and main bus bar, I don't find any information about.
- My avionic aquipment are : SL-40 com, Xpdr GTX-328, Pm1000 II, Dynon D10a, Gps 695, Ubg16. Total Amp is 22, first average CB is 25, your genaral idea ? The wire for Toggle switch Avionic Master will do a short trip, about 8 inches for 25Amp, it's a standard wire or I need something different regarding the slalom between the copper bar and CBs ?
- My engine intruments are Van's analog standar : Oil Press, Oil Temp, Fuel Press, Fuel Levels, Tachometer. I would like to put all this stuff on an engine intruments CB, have you idea of their amp load ?
- I did a right panel a la Paul Dye, I've three rows of CB, which is the best mode to connect the rows together ? I tried a 8Awg wire (P13) and a piece of copper bus bar, I don't figure which is better ...
- My clock will be on always Hot terminal, how did you wired the always hot stuff (from where)
Thanks in advance
I'm sure you think that some are dummy questions but I'm surfing into a little bit confusion...thanks for patience.
My is a Rv8, bus bar with avionic master, circuit breakers, sky-tec starter
- I like to put a CB between ACS starter block and main bus bar, I don't find any information about.
- My avionic aquipment are : SL-40 com, Xpdr GTX-328, Pm1000 II, Dynon D10a, Gps 695, Ubg16. Total Amp is 22, first average CB is 25, your genaral idea ? The wire for Toggle switch Avionic Master will do a short trip, about 8 inches for 25Amp, it's a standard wire or I need something different regarding the slalom between the copper bar and CBs ?
- My engine intruments are Van's analog standar : Oil Press, Oil Temp, Fuel Press, Fuel Levels, Tachometer. I would like to put all this stuff on an engine intruments CB, have you idea of their amp load ?
- I did a right panel a la Paul Dye, I've three rows of CB, which is the best mode to connect the rows together ? I tried a 8Awg wire (P13) and a piece of copper bus bar, I don't figure which is better ...
- My clock will be on always Hot terminal, how did you wired the always hot stuff (from where)
Thanks in advance