High_Flyer
Well Known Member
Hello everyone,
Yesterday I installed the rollbar on my RV-7. I then dismanteled it and saw this:
![](/proxy.php?image=http%3A%2F%2Fi1134.photobucket.com%2Falbums%2Fm604%2FHighFlyer_68%2FIMG_01961.jpg&hash=8447fddf8a30417f39f21791c0017616)
Obviously there is an edge distance issue here with the hole on the F631A channel.
These are the holes through which the AN 509-10R10 screws are going in (see pic below). The edge distance inside is good as there is another strip of aluminum F631B-L. The The F631A aft channel where the mistake is located is sandwiched between two pieces.
Is that a problem??
Thanks and Merry Christmas to all.
Alain.
![](/proxy.php?image=http%3A%2F%2Fi1134.photobucket.com%2Falbums%2Fm604%2FHighFlyer_68%2FRV-7plancapture.jpg&hash=e733c38813c13cfc60608d69832a2c94)
Yesterday I installed the rollbar on my RV-7. I then dismanteled it and saw this:
![](/proxy.php?image=http%3A%2F%2Fi1134.photobucket.com%2Falbums%2Fm604%2FHighFlyer_68%2FIMG_01961.jpg&hash=8447fddf8a30417f39f21791c0017616)
Obviously there is an edge distance issue here with the hole on the F631A channel.
These are the holes through which the AN 509-10R10 screws are going in (see pic below). The edge distance inside is good as there is another strip of aluminum F631B-L. The The F631A aft channel where the mistake is located is sandwiched between two pieces.
Is that a problem??
Thanks and Merry Christmas to all.
Alain.
![](/proxy.php?image=http%3A%2F%2Fi1134.photobucket.com%2Falbums%2Fm604%2FHighFlyer_68%2FRV-7plancapture.jpg&hash=e733c38813c13cfc60608d69832a2c94)