Had to replace my D-100 due to display issue and am trying to calibrate the AoA with my backup replacement D-100. It has been a looong time since I calibrated the AoA and following the instructions in the install manual I am not sure the system is working right. It says to push the STALL button and a 45 sec timer starts within which you have to compete the selected stall but when I push the STALL button nothing happens, no change to screen, no pop up timer etc. I cannot remember how it worked before and when I did it it was probably a few firmware revisions back. I realize it is an old legacy system but has anyone done the Dynon D-10 AoA calibration recently and give me a few clues as to what I may be doing wrong. I believe the Skyview approach is different.
I plan on trying again today but thought the brain trust might have the answers.
Thanks
Figs
I plan on trying again today but thought the brain trust might have the answers.
Thanks
Figs
