I'll most likely call the factory about this. It's one of those things that I don't *think* would create a problem, but I'll check.
Has anyone drilled additional tubing holes in the center spar box, specifically just the aft one, other than the standard one outbound one on each side, and the two in the center? I am routing my pitot and AOA lines on the left side, which will be running up behind the center spar cap and then under the canopy deck forward to the instrument panel. But the one outboard hole in the aft bulkhead can't fit both of the lines through. I was thinking of just drilling an additional penetration right above the existing one for running the AOA line. Likewise, maybe one additional hole over on the right side somewhere (that RG-400 is relatively thick!). Opinions? Thanks.
Has anyone drilled additional tubing holes in the center spar box, specifically just the aft one, other than the standard one outbound one on each side, and the two in the center? I am routing my pitot and AOA lines on the left side, which will be running up behind the center spar cap and then under the canopy deck forward to the instrument panel. But the one outboard hole in the aft bulkhead can't fit both of the lines through. I was thinking of just drilling an additional penetration right above the existing one for running the AOA line. Likewise, maybe one additional hole over on the right side somewhere (that RG-400 is relatively thick!). Opinions? Thanks.