FALC0NDRIVER
Member
I just made a blunder while relocating my fuel pickup fitting. I'm adding a flop tube to a QB wing. I drilled out the center/aft most rivet on the T-405 thick angle (near the leading edge). I forgot to measure back 1 1/16" like the plans call for and just used the rivet hole as the pilot for my unibit. Now the AN fitting sits about 1 3/8" back. Will this cause complications when mating the wings and plumbing the fuel lines?
I got carried away building a unibit extension and forgot to look at the plans one final time before drilling.![Mad :mad: :mad:](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
I got carried away building a unibit extension and forgot to look at the plans one final time before drilling.