romanov
Well Known Member
Hi Guys ,
I need your educated opinion here, we damaged a
dimpled holes a bit, what do you think is it so
bad that requires a new skin?
here is what happened:
We just started to scuff the VS skin (VS-801PP)
as a preparation for priming / coating.
Accidentaly we applied too much force on the inner side where dimpled cone is.
As a result there are a few dimpled holes that are a bit larger now: (about 0.15mm) and they are a bit flatened , you can see the results on pictures attached. Also
have to add here that the front side of the holes is
completely fine.
Please advise if it may cause a problem or may affect the structure strenght.
The big question now is , whether we can continue with that skin or we have to order a new one.
Looking forward for your recommendations.
check that album for illustration:
https://imgur.com/a/Oes7Ocq
Blogging my RV14 here:
https://bit.ly/2PzjPzS
I need your educated opinion here, we damaged a
dimpled holes a bit, what do you think is it so
bad that requires a new skin?
here is what happened:
We just started to scuff the VS skin (VS-801PP)
as a preparation for priming / coating.
Accidentaly we applied too much force on the inner side where dimpled cone is.
As a result there are a few dimpled holes that are a bit larger now: (about 0.15mm) and they are a bit flatened , you can see the results on pictures attached. Also
have to add here that the front side of the holes is
completely fine.
Please advise if it may cause a problem or may affect the structure strenght.
The big question now is , whether we can continue with that skin or we have to order a new one.
Looking forward for your recommendations.
check that album for illustration:
https://imgur.com/a/Oes7Ocq
Blogging my RV14 here:
https://bit.ly/2PzjPzS
Last edited: