Lionclaw
Well Known Member
This has been bugging me for a while. I can't rivet my baggage floor down until the wiring is settled.
I'm thinking about putting 2 pieces of conduit under the baggage floor as shown. The strobe power supply will mount on the side just behind the baggage bulkhead, the pitch servo will go next to the bellcrank, and the ELT will mount to the side of the in-line floor rib. The wiring to the tail will run along the j-channel through the tail cone.
1. Am I missing anything?
2. Recommended way of supporting the conduit? 1/8" holes and zip ties through baggage ribs?
3. What should I do with the ELT antenna?
Help!
I'm thinking about putting 2 pieces of conduit under the baggage floor as shown. The strobe power supply will mount on the side just behind the baggage bulkhead, the pitch servo will go next to the bellcrank, and the ELT will mount to the side of the in-line floor rib. The wiring to the tail will run along the j-channel through the tail cone.
1. Am I missing anything?
2. Recommended way of supporting the conduit? 1/8" holes and zip ties through baggage ribs?
3. What should I do with the ELT antenna?
Help!
Last edited: