Hi Everyone,
I just wanted to verify my countersinking technique before diving in.
Should I adjust the countersinking tool so that a flush rivet sits just slightly up above the surface, knowing that the rivet will get squeezed flush with the skin when riveted?
IE, i should err on the side of countersinking too little than too much. THe deper the countersink hole is, the rivet may risk sitting too lose in its hole?
Thanks,
Jae
I just wanted to verify my countersinking technique before diving in.
Should I adjust the countersinking tool so that a flush rivet sits just slightly up above the surface, knowing that the rivet will get squeezed flush with the skin when riveted?
IE, i should err on the side of countersinking too little than too much. THe deper the countersink hole is, the rivet may risk sitting too lose in its hole?
Thanks,
Jae