Conrol Stick hardware question

[rv12iS-builder]

Drawing 38 shows a brass bushing inserted into the WD-611 control stick, and an AN4-27 bolt inserted into the brass bushing. Is the bushing supposed to be stationary so the stick moves around the bushing, or is the bushing supposed to rotate around the AN4 bolt?

Thank you,

 

[scard]

The bushing is definitely supposed to be stationary. There is a note that the bushing should be something like 1/64" longer on each end of the weldament so that it can be clamped by the bolt. The weldament rotates on the bushing, not the bushing on the bolt.