I hope someone can help me with this. My existing Manifold pressure line is 1/4 in nylon tubing. I am installing an insight G3 analyzer which has an AN-2 male flare fitting. Normally AN-2 would connect to aluminum tubing of 1/8 in OD.
I can tee off of the nylon tubing and run 1/4" OD nylon tubing to the insight G3, but I'm stumped on how to connect the 1/4" OD nylon to an AN-2 male flare. After searching Spruce for options, I can not find any elegant solutions.
Any ideas ( perhaps with part numbers from spruce or others)
Thanks!
I can tee off of the nylon tubing and run 1/4" OD nylon tubing to the insight G3, but I'm stumped on how to connect the 1/4" OD nylon to an AN-2 male flare. After searching Spruce for options, I can not find any elegant solutions.
Any ideas ( perhaps with part numbers from spruce or others)
Thanks!