tx_jayhawk
Well Known Member
I recently got a shiny new 0-360 Superior roller tappet engine (no recall thanks goodness) from Bart at Aerosport, and I will soon be mounting it. I am curious if anyone might have developed a checklist of all things ideally needing done prior to engine mounting (hopefully it only goes on once?). For example...I have the folllowing done:
* solenoid / relay mounting
* battery box
* brake reservoir
* cabin heat vent
* gascolater
* others?
Since I am pretty much going the straight 360 route, I assume I should go ahead and drill holes for the throttle and mixture per Vans FF Fwd plans? Any other gotchas or things I need to ensure are done prior to mounting?
Also, if there is anyone in the Kansas City area that has an engine hoist that might be rented or borrowed it would be appreciated.
Thanks,
Scott
7a Finishing
* solenoid / relay mounting
* battery box
* brake reservoir
* cabin heat vent
* gascolater
* others?
Since I am pretty much going the straight 360 route, I assume I should go ahead and drill holes for the throttle and mixture per Vans FF Fwd plans? Any other gotchas or things I need to ensure are done prior to mounting?
Also, if there is anyone in the Kansas City area that has an engine hoist that might be rented or borrowed it would be appreciated.
Thanks,
Scott
7a Finishing