Hey guys,
Sorry to ask this, but I'm not following you with regards to orientation. If I have my crank flange setup so it's pointed up at TDC, I would think the prop could go on in any of the 6 bolt patterns...therefore, 6 combinations to try. Am I missing something? Or does it not matter which blade is pointed up or down? From one of the posts above, it seems that there are at least 3 different combinations to try.
Also, do you need to use the crush plate for the Catto 3-blade?
I guess I should also ask about torquing the prop bolts...I didn't get an installation sheet or paperwork of any kind from Catto. I've read that most people torque to 45 ft. lbs. Is that right?