carb bolt

[godspeed]

ok whats the trick tool for putting the carb with the
cable bracket , I have one of the nuts has very little
room (the front left stud) special tool ? whats the trick ?

Danny..

 

[OneTwoSierra]

For me its stubby wrenches. I couldn't have built my 9 without them. Also, there are ratcheting box end wrenches that work well, but I can't remember using them in this area. Good luck.

 

[sf3543]

You have to get all the nuts started, but just barely and then start the close clearance ones in back. From that point, just keep tightening them down as you can. You actually want to grind down an open end wrench a little to allow for a better fit, if you have to. I have a few sacrificial tools that have been ground to fit into tight spaces.