I'm working on fitting the canopy side weldment (WD-725) for a tip up, but I have a gap at one end where it meets the aft channel ribs (W-631A) that is too large to close by just clamping. I've attached a photo. No matter what I , the gap doesn't seem to improve without risking breaking the weld on the angle. Has only seen this before and how to I get this gap closed? Everything on the aft channel looks good and square. Everything else on the side weldment looks good too.
The gap on the inboard end is 3/16". On the outboard end, it is flush. The side weldment on the other side is perfect.
Here's a photo:
Thanks!
Vince
N567VB
The gap on the inboard end is 3/16". On the outboard end, it is flush. The side weldment on the other side is perfect.
Here's a photo:
![863652531493b24a871d8d.jpg](/proxy.php?image=http%3A%2F%2Fwebsites.expercraft.com%2Fvinceb%2Fimages%2F863652531493b24a871d8d.jpg&hash=65d2faff97f9820bd984f98aba036470)
Thanks!
Vince
N567VB