dick seiders
Well Known Member
Need some input here please. I have checked out my EDC10 and it's installed correctly. All systems are communicating with the 180k. I have set the Mag Cal intensity and inclination. Tomorrow I will place the RV12 on the compass rose, turn on all powered components (as per Dynon Support) and set the 4 directions as called for in the Installation Manual. This is supposed to set the compass heading. My question for those who have succeeded in doing this is: will the 180 compass show the direction I am pointing the airplane at while on the compass rose? I am not being cute here. I really don't know what I should expect to see on the EFIS heading. (in the past tries the heading indicated was not always the case, but I did not have any of the other components turned on before).
This presently is the only remaining issue I have with the 180, and I want to do it right and close this tiresome chapter with the Dynon.
Appreciate any input.
Dick Seiders 120093
This presently is the only remaining issue I have with the 180, and I want to do it right and close this tiresome chapter with the Dynon.
Appreciate any input.
Dick Seiders 120093