I recently purchased the mod kit for my Avery C-Frame to allow me to rivet using a 12" back rivet set. Now the base of my set will accept a standard cup set for a rivet gun. I see how this can work with universal head rivets and small components held by hand, but how can I use the C-frame to back rivet flush rivets on large control surfaces? I see two options:
1. Build a table that is the same height as a mushroom set placed in the base of the C-frame
2) Build a very ridged table that goes over the C-frame without a hole where I can lay a full-sized back rivet plate.
Any advise or options from people who have done this would be appreciated.
1. Build a table that is the same height as a mushroom set placed in the base of the C-frame
2) Build a very ridged table that goes over the C-frame without a hole where I can lay a full-sized back rivet plate.
Any advise or options from people who have done this would be appreciated.