I have the matco brake setup, and back when I installed everything I ended up forgetting to install the 90 degree elbow on the caliper before I installed my wheel pant bracket. I really don't want to pull the wheels off so that I can unbolt my wheel pant bracket to gain access to thread on my elbow.
I can thread on a 45 degree AN fitting by flexing the bracket a little. Does anyone see a problem doing that? The only thing I can think of is, it will place my brake line higher up next to the wheel pant bracket. I dont know if this would be an issue if my pants broke up on landing like a few have. I dont know if the bracket would possibly jam into my brake line.... That's quite the stretch to a bad situation, but you never know.
Maybe I need to just suck it up and pull the wheels off again...![Eek! :eek: :eek:](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
I can thread on a 45 degree AN fitting by flexing the bracket a little. Does anyone see a problem doing that? The only thing I can think of is, it will place my brake line higher up next to the wheel pant bracket. I dont know if this would be an issue if my pants broke up on landing like a few have. I dont know if the bracket would possibly jam into my brake line.... That's quite the stretch to a bad situation, but you never know.
Maybe I need to just suck it up and pull the wheels off again...
![Brake.jpg](/proxy.php?image=https%3A%2F%2Flh5.googleusercontent.com%2F-ScXZphGyhL4%2FV2dNrNGdxZI%2FAAAAAAAABPg%2Fb8wCWzNrSWs5pZvesXwXTmwmorianEn4QCL0B%2Fw653-h474-no%2FBrake.jpg&hash=8dba516ca1345923d4f432419582515b)