Bending elevator tab for trim tab cut out

[Mike Coady]

I am a new builder and just purchased a quickbuild kit that has most of the tail feathers already completed. I am beginning with the left elevator and need to bend the tabs on the skin where the trim tab will be, as well as bend the trim tab ends themselves. I need advice on how to bend so I don't start the project with an initial mistake.

 

[Transporter]

Trim Tab Ends

See this thread:
http://www.vansairforce.com/community/showthread.php?t=32314&highlight=bending+trim+tab&page=2

The blocks and clamps on the second page work well. Don't use soft wood. Use good double sticky (carpet) tape and you should have good results.

Good luck!
Mike