JonJay
Well Known Member
I have rigged my Pitch servo directly to the Elevator Bell Crank by using a longer AN3 bolt that secures the Elevator Push Rod and some appropriate washers for spacers. Control operations seem very secure, free, and smooth. I have seen other methods of attaching the Push Rod to the Elevator Bell Crank by riveting a small tab, but my approach seems to be clean and workable. I am using the Blue Mountain Autopilot which has mulitple steps in the control arm as well as the ability to adjust sensitivity through software.
I have also rigged my Roll servo in the same manner by extending the bolt that holds the hex tube/cross over rod end. Again, free and clear and smooth.
Has anyone else done this or have any comments or concerns?
I have also rigged my Roll servo in the same manner by extending the bolt that holds the hex tube/cross over rod end. Again, free and clear and smooth.
Has anyone else done this or have any comments or concerns?