So my beautiful but very expensive Andair fuel valve arrived from Van's yesterday.
The AN ports are aimed sideway and I would like to rotate them 90° so they point down. The four little screws are not attached and the fittings wiggle a bit but resists gentle efforts to remove them.
Am I correct in assuming that the resistance I feel is an internal 'O' ring and I just need to pull harder?
I'm very reluctant to use any undue force as this valve was sooooo expensive. (although $25 cheaper at Van's compared to AS)
The AN ports are aimed sideway and I would like to rotate them 90° so they point down. The four little screws are not attached and the fittings wiggle a bit but resists gentle efforts to remove them.
Am I correct in assuming that the resistance I feel is an internal 'O' ring and I just need to pull harder?
I'm very reluctant to use any undue force as this valve was sooooo expensive. (although $25 cheaper at Van's compared to AS)
Last edited: