rjcthree
Well Known Member
I'm loosing my marbles over this one. Two tries on visibly clean up damaged surfaces and I cannot get my oil screen nut to not leak. It not even running yet....
Clean, dry, 135 deg ( and the beyond) from contact....drips into the FAB! Messy! I'm halfway to Benders blue loctite method. Actually, I have loctite crankcase half sealant, hmmm.
Is there an alternate here? Any advice? The AN900-16 (correct per manual) were from ACS.
Thanks, Rick.
Clean, dry, 135 deg ( and the beyond) from contact....drips into the FAB! Messy! I'm halfway to Benders blue loctite method. Actually, I have loctite crankcase half sealant, hmmm.
Is there an alternate here? Any advice? The AN900-16 (correct per manual) were from ACS.
Thanks, Rick.