Hello everyone, I am trying to finalize the pinout on my Garmin 430W tray and would really appreciate it if someone with more experience could review the items I crossed out in green to see if there are in fact some that shouldn't be corssed out. I think I have it down but I don't know what I don't know. I also am thinking to myself "dang, there is a lot of open spots in them connectors". I would really appreciate it, even if you could direct me with where to go for more info!
P.S. I read the manual, it doesn't give detailed descriptions for most of this stuff. Or descriptions that a noob like myself can understand sometimes Most of it was based off of looking at the drawings.
Also attached is my panel. All Dynon through an ARINC-429. Com is a GTR-200 and audio panel is a GMA-245.
Mega thanks in advance!
4001-1 by Jereme Carne, on Flickr
4001-2 by Jereme Carne, on Flickr
4002 by Jereme Carne, on Flickr
4006 by Jereme Carne, on Flickr
FINAL PANEL by Jereme Carne, on Flickr
P.S. I read the manual, it doesn't give detailed descriptions for most of this stuff. Or descriptions that a noob like myself can understand sometimes Most of it was based off of looking at the drawings.
Also attached is my panel. All Dynon through an ARINC-429. Com is a GTR-200 and audio panel is a GMA-245.
Mega thanks in advance!
4001-1 by Jereme Carne, on Flickr
4001-2 by Jereme Carne, on Flickr
4002 by Jereme Carne, on Flickr
4006 by Jereme Carne, on Flickr
FINAL PANEL by Jereme Carne, on Flickr