Bill Whitefield
Member
I am planning on a panel upgrade that started out with just relocating the two GPS antennas from their present location over the forward baggage compartment. It has quickly grpwn into a desire to do a total panel upgrade. I would like to remote a new Dynon #2 radio, transponder, and ADSB in boxes in the empennage along with placing the Garmin and Dynon antennas directly behind the rear seat under the canopy. The builder ran an impressive bundle of wire coming forward from the empennage (rudder trim, elevator trim, pitch trim, ADAHARS, thermocouple, VOR antenna, strobe and ELT) which has pretty much filled up the pass through holes in the spar. Any suggestions on how to get the additional wiring for the remote boxes back to the empennage?
I know a lot of folks mount their GPS antennas in the engine compartment. Has this installation location worked well? I will be using a Garmin 650 and Dynon Skyview HDX. Thanks in advance for your input.
Bill
I know a lot of folks mount their GPS antennas in the engine compartment. Has this installation location worked well? I will be using a Garmin 650 and Dynon Skyview HDX. Thanks in advance for your input.
Bill