drone_pilot
Well Known Member
Hello All,
I'm riveting the tail cone of my RV-14A together. There are a couple of #30 holes that I didn't dimple on the rear of the left and right skins, however I did manage to dimple the bulkheads under the holes. The problem is that I discovered this after I have riveted the side skins to about 99%.
Is is acceptable to dimple the outer skin thru the bulkhead since everything is pretty much finished at this point? I can reach the holes with my pneumatic squeezer.
I have built a -7A already but don't remember making a mistake like this.
I'm riveting the tail cone of my RV-14A together. There are a couple of #30 holes that I didn't dimple on the rear of the left and right skins, however I did manage to dimple the bulkheads under the holes. The problem is that I discovered this after I have riveted the side skins to about 99%.
Is is acceptable to dimple the outer skin thru the bulkhead since everything is pretty much finished at this point? I can reach the holes with my pneumatic squeezer.
I have built a -7A already but don't remember making a mistake like this.