Page 10-7 wants me to put the tailcone on two sawhorses at least 38" high.
I went forward through the plans, but I can't tell why this is required. The only 38" sawhorses I could find did not have good reviews. Is there any reason I can't use a 32" sawhorse that's more commonly available?
EDIT: I figured out the reason, the plans want you to assemble the tailcone upside down. I think I'm just going to go with a 32" sawhorse and lay under it during assembly.
I went forward through the plans, but I can't tell why this is required. The only 38" sawhorses I could find did not have good reviews. Is there any reason I can't use a 32" sawhorse that's more commonly available?
EDIT: I figured out the reason, the plans want you to assemble the tailcone upside down. I think I'm just going to go with a 32" sawhorse and lay under it during assembly.
Last edited: