Well I was out in the garage doing my first work on the tail section. I mounted the Scotchbrite wheel. I was using the Scotchbrite wheel to cleen up the edges of the HS-603pp. The inboard bottom edge of this caught on the Scotchbrite wheel and bent the corner. This is the very center of the rear spar near where the bearing is located. I took the following pictures of the area in question.
I plan on calling Vans, but I wanted to get some feedback from fellow builders as well.
Also please please please give me some idea of the best edge deburring technique. I don't seem to be able to do this well.
Big pictures lie ahead.
Image 1
Image 2
Image 3
Image 4
I plan on calling Vans, but I wanted to get some feedback from fellow builders as well.
Also please please please give me some idea of the best edge deburring technique. I don't seem to be able to do this well.
Big pictures lie ahead.
Image 1
Image 2
Image 3
Image 4