Quick question before I chop this up...
Getting back into the fuse after a few years away. I've looked at the inventory, it looks like there is only one piece of .063 3/4x3/4 angle, the 12' long piece.
I can't think of anything else that might need a piece of angle that long, but before I cut it to make the F-832D I wanted to make sure that's the right source for the material.
Thanks in advance!
Getting back into the fuse after a few years away. I've looked at the inventory, it looks like there is only one piece of .063 3/4x3/4 angle, the 12' long piece.
I can't think of anything else that might need a piece of angle that long, but before I cut it to make the F-832D I wanted to make sure that's the right source for the material.
Thanks in advance!