UnPossible
Well Known Member
Hey - My finish kit was just delivered last week and it's time to get busy on the doors.
Looking at the plans, there are "minimum" trim dimensions listed. (ex. on the outer door, the minimum flange around the door opening is listed as 3/4" outside the scribe line.)
For those that have already finished these steps, am I same to cut the doors pretty much right up to the minimums, or should I leave an extra 1/16". 1/8", etc?
Between building my 7A and now this 10, there have been enough call outs in the plans that in hindsight I wish I had left a little more material than called out in the plans.
I don't want to have to go back and retrim this 100 times, but I really don't want to trim it too close and have to add back material!
Thanks,
Jason
Looking at the plans, there are "minimum" trim dimensions listed. (ex. on the outer door, the minimum flange around the door opening is listed as 3/4" outside the scribe line.)
For those that have already finished these steps, am I same to cut the doors pretty much right up to the minimums, or should I leave an extra 1/16". 1/8", etc?
Between building my 7A and now this 10, there have been enough call outs in the plans that in hindsight I wish I had left a little more material than called out in the plans.
I don't want to have to go back and retrim this 100 times, but I really don't want to trim it too close and have to add back material!
Thanks,
Jason