LRU configuration status invalid

Hi all
I powered up my panel yesterday for the first time.
No smoke thankfully.
Most things seem to be behaving as expected except I get an “invalid” configuration status for my GEA24
Any ideas what may be causing this?
The software is all up to date and the Can bus is all sweet. I have it also connected to the MFD via RS232 and this seems to be configured correctly too.
Any thoughts?
Cheers
Richard

Yes

Here is what I would do:
1)On the PDF go into configuration mode (hold "menu" button during turn on.
2) Starting in the upper left, go thru each menu and configure each "block"
3) one of the blocks will show network status; it should be all green

It took me an hour to get it all set.

if the GEA24 is hooked up, you should see a new box near the bottom of the page.

Lastly, if all else fails, read the manual.

Thanks for you promt reply John.
This is my 3rd G3X install and I am guilty of skipping ahead and I did indeed do something silly.
All fixed now.
Cheers