Not liking laser cut parts, even with proper prep, including extra reaming, single flute deburr, and good dies, still getting some slight cracking that I have to file out.
Just needed to rant, but I did send support a message about this, because I think there are going to be a lot of cracks in the next few years.
These are after an hour of filing and pad work, start of cracks all on the same position. I should have taken shots with the original, after each prep step, but didn't.
Just needed to rant, but I did send support a message about this, because I think there are going to be a lot of cracks in the next few years.
These are after an hour of filing and pad work, start of cracks all on the same position. I should have taken shots with the original, after each prep step, but didn't.
Last edited: