I’m working on my RV-14 elevators, page 09-08, Step 6. There is a zoomed in inset on Figure 3 showing the shear clip (E-1022) right next to the two close out bends on the top and bottom skin. Page 09-22 shows that the close out tabs and the shear clip get riveted together.
My issue is I have a 1/8” gap between the shear clip and the close out tabs. Did I bend the tabs in the wrong spot? Any thoughts?
Thanks!
My issue is I have a 1/8” gap between the shear clip and the close out tabs. Did I bend the tabs in the wrong spot? Any thoughts?
Thanks!