Alright ,ready to attach F303 spar attach bulkhead I am building this station in a hard jig with a precise floor so I am building this station in place, I would like to not install the f303f The 2 5/8"strip that holds the f303 half's together if you premake this station. I am wondering if there is any structural concerns in omiting this part. The advantage in omitting it is better fits and more purchase on the forward corner angles and nicer fitting joggles on the aft side ribs. for the traverse loads I can't imagine it adding strength to the spar bars that are almost in contact with it. In the longitudinal there is a possible tiny reduction but there is a 2 3/4 lap joint held together with 50 rivets that is .072" thick. I think I would prefer to ommit it and have better fitting attaches in the corners What do you think?