rmartingt
Well Known Member
My avionics and engine wiring is basically complete; I have a few interior accessories and lights left to connect. My brake pedals are set up, engine control cables are installed. What I know I have left that I'd like to do befire riveting is:
A couple wire clamps on the firewall
Interior lighting wiring
ELT remote wiring
RH 5V outlet
Basic avionics power-on checks
Paint and final install rollbar
Final install canopy tracks
At that point I think everything on/aft of the firewall will be installed and the forward skin will be ready to rivet. My forward skin has access panels and I've verified I can reach all components and wires between the subpanel and the firewall through them (though it may be awkward).
At this point us there anything left to do before riveting? I'd like to get it on so I can progress to canopy and FWF but I don't want to trap myself either.
A couple wire clamps on the firewall
Interior lighting wiring
ELT remote wiring
RH 5V outlet
Basic avionics power-on checks
Paint and final install rollbar
Final install canopy tracks
At that point I think everything on/aft of the firewall will be installed and the forward skin will be ready to rivet. My forward skin has access panels and I've verified I can reach all components and wires between the subpanel and the firewall through them (though it may be awkward).
At this point us there anything left to do before riveting? I'd like to get it on so I can progress to canopy and FWF but I don't want to trap myself either.