Hey folks- just added a 2nd Comm while down for first conditional. Now I have IFD540 as COMM 1 and Dynon as COMM 2 (was only comm before). Antennas are both belly mounted side by side about 18" (need tot measure) apart.
I was using COMM 2 (TX/RX) on Tue flying back and COMM 1 was on RX on guard. Pilot buddy in right seat noticed the IFD rx light triggering on guard when we'd transmit on the Dynon. I need to check and see if we see the same behavior if we switch the transmitting radio
Is this normal behavior given the radios are so close and one is so close it's blowing through (don't know the correct term to use) the other one even though they are not on the same freq?
If not- any recommendations.
Thanks in advance
I was using COMM 2 (TX/RX) on Tue flying back and COMM 1 was on RX on guard. Pilot buddy in right seat noticed the IFD rx light triggering on guard when we'd transmit on the Dynon. I need to check and see if we see the same behavior if we switch the transmitting radio
Is this normal behavior given the radios are so close and one is so close it's blowing through (don't know the correct term to use) the other one even though they are not on the same freq?
If not- any recommendations.
Thanks in advance