Home > VansAirForceForums

-Advertise in here!
- Today's Posts | Insert Pics

Keep VAF Going
Donate methods

Point your
camera app here
to donate fast.

Prev Previous Post   Next Post Next
Old 11-25-2011, 04:55 PM
vmirv8bldr's Avatar
vmirv8bldr vmirv8bldr is offline
Join Date: Jun 2005
Location: Eastvale, CA
Posts: 378
Default Need help with SJ cowl!!!

I need some assistance from anyone who has an SJ cowl on their 8. Specifically, Measurements along the cut line from FW to inlet on both sides. If you happen to have a Whirlwind RV200 and a Barrett IO-390, you're my new best friend.

Long story short, after getting the horizontal hinges installed on the bottom cowl, I put it on the plane and the hinge eyes are in contact with the valve cover on Cyl #2, front LEFT. Cyl #1 (front RIGHT) has about 1/4" clearance. Theoretically, Cyl #1 should be the tightest fit since it is the forward-most cylinder.

Obviously, this cowl is unusable but I need to figure out what caused this before starting over. Any ideas?

Barrett IO-390
Whirlwind 200RV (CS) prop and spinner
Sabre 2.5" Prop extension

Bart Filipiak
Eastvale, CA
RV-8 N74VB

Barrett IO-390
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT -6. The time now is 05:56 PM.

The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.