Hello all,
It's getting a bit crowded running wires to the Rotax capacitor, is it ok to run them to a terminal strip, then a single wire to the capacitor? Or is that too much load? (ignore the wires above the capacitor, those are in process) I was thinking about a simple strip under the capacitor, with one wire going to the + terminal.
Thanks,
Steve
click here for a full sized image: http://seareybuild.blogspot.com/2021/02/vaf-images.html
Note: corrected, the capacitor has to do with the Rotax engine, not the Dynon avionics. My bad, see post below.
It's getting a bit crowded running wires to the Rotax capacitor, is it ok to run them to a terminal strip, then a single wire to the capacitor? Or is that too much load? (ignore the wires above the capacitor, those are in process) I was thinking about a simple strip under the capacitor, with one wire going to the + terminal.
Thanks,
Steve
click here for a full sized image: http://seareybuild.blogspot.com/2021/02/vaf-images.html
Note: corrected, the capacitor has to do with the Rotax engine, not the Dynon avionics. My bad, see post below.
Last edited: