Mike S
Senior Curmudgeon
The Ray Allen SPD-1 speed control looks to be a voltage dropping device that not only slows down the servo, but also reduces the force the servo will generate.
Has anybody had an issue with using this speed control and then not having enough force to drive the trim tab?
Is there a better way to slow the servo down but not reduce the force it generates at the same time? Possibly some kind of pulsed full voltage signal?
Thanks in advance.
Mike
Has anybody had an issue with using this speed control and then not having enough force to drive the trim tab?
Is there a better way to slow the servo down but not reduce the force it generates at the same time? Possibly some kind of pulsed full voltage signal?
Thanks in advance.
Mike