rdamazio
Well Known Member
Hi everyone.
I'm trying to get my fuselage side skins bent with the wood jig per instructions on 29-4.
I was happy that I got it to the 60-degree angle they ask for, but when I cleco it on, it's clearly not flush around the holes, and the edge is lifted away from the other skin:
https://photos.app.goo.gl/F4BgYhqAGPAyAr6YA
Any suggestions on this? Should I bend it beyond the 60 degrees? Crease near the edge? I've looked through some blogs where everyone says theirs just sit perfectly after bending.
Thanks
Rodrigo
I'm trying to get my fuselage side skins bent with the wood jig per instructions on 29-4.
I was happy that I got it to the 60-degree angle they ask for, but when I cleco it on, it's clearly not flush around the holes, and the edge is lifted away from the other skin:
https://photos.app.goo.gl/F4BgYhqAGPAyAr6YA
Any suggestions on this? Should I bend it beyond the 60 degrees? Crease near the edge? I've looked through some blogs where everyone says theirs just sit perfectly after bending.
Thanks
Rodrigo