bkc3921
Well Known Member
Sorry, but this is driving me crazy. When building the LEFT wing skeleton, Page 15-05 Figure 1 shows the inboard nose rib with the following description: "W-1208-R fwd and aft trimmed with TWO attached nutplates"...the instructions for building this rib is on Page 15-02 Figure 4...which clearly shows only ONE nutplate being installed. The AOA device attaches, and the nutplate is used for grounding some wires......................When you get to the RIGHT wing, its even worse...Page 15-07 Figure 1 shows the inboard nose rib with basically the same instruction, with THREE nutplates installed. Again, the building of this rib is accomplished as before, Page 15-02 Figure 4, showing only ONE nutplate installed. Yes, I could simply put additional nutplates on, but I always like to know why I'm doing something. Can anyone address this?...I would like a definitive answer on the number of nutplates on these 2 nose ribs in question. Am I missing something?... Thanks in advance.
Last edited: