Need to plumb a Dynon MAP Sensor and two Elec Igns to the vacuum system. The Van's kit has a braided line which is fine, but I will need to transition to conventional vacuum tube for the Dynon and Ign ports.
Has anybody seen or tried using a high quality, high-temp rated silicone hose started from at an AN hose barb fitting at the engine cylinder?
An example of the hose type...
https://www.amazon.com/High-Performance-Silicone-Vacuum-Hose/dp/B008N0VTQI
David
Has anybody seen or tried using a high quality, high-temp rated silicone hose started from at an AN hose barb fitting at the engine cylinder?
An example of the hose type...
https://www.amazon.com/High-Performance-Silicone-Vacuum-Hose/dp/B008N0VTQI
David