Hi Experts
I have two SL30 being set up in a new panel. SL30 #1 talks via serial to the PFD and #2 talks via serial to the MFD. Both SL30 heads are configured for serial.
Both G3X's have their RS232 ports configured for Garmin Nav/Com. Navigation is setup for Nav 1&2.
I see both Comm frequencies top left and right as expected on the 2 G3Xs. I can send new frequecies to each but I cannot set standby on the SL30's from either G3X and I never get a CDI on either panel. Both show the NAV's Xed out.
So far this seems to mean that I am tranmitting serial to the panels but not receiving serial. I have checked the pin outs and gone so far as to make a test harness. Exactly the same. Since both are doing exactly the same thing I suspect configuration but have tried every other garmin oe nmea protocol.
Any other possible config issue I might be missing?
Thanks for the help
Michael B
I have two SL30 being set up in a new panel. SL30 #1 talks via serial to the PFD and #2 talks via serial to the MFD. Both SL30 heads are configured for serial.
Both G3X's have their RS232 ports configured for Garmin Nav/Com. Navigation is setup for Nav 1&2.
I see both Comm frequencies top left and right as expected on the 2 G3Xs. I can send new frequecies to each but I cannot set standby on the SL30's from either G3X and I never get a CDI on either panel. Both show the NAV's Xed out.
So far this seems to mean that I am tranmitting serial to the panels but not receiving serial. I have checked the pin outs and gone so far as to make a test harness. Exactly the same. Since both are doing exactly the same thing I suspect configuration but have tried every other garmin oe nmea protocol.
Any other possible config issue I might be missing?
Thanks for the help
Michael B