Foghorn
Well Known Member
Perhaps I've done something incorrectly. I'm going to call WW on monday but wanted to see if anyone else has had this issue.
The spinner will not going any further than what you see below. The spinner has a bulkhead with an opening for the prop cap to snugly fit into with a 3/8" flange facing aft. The flange is going past the hex nuts but the bulkhead is hitting the nuts and stopping.
You can see the wear marks in this pic showing the flange seating between the cap and nuts.
I tried to use the new forum attachment feature but it rotates my pictures 90 degrees every time. Anyone know how to fix that issue too?
Thanks
The spinner will not going any further than what you see below. The spinner has a bulkhead with an opening for the prop cap to snugly fit into with a 3/8" flange facing aft. The flange is going past the hex nuts but the bulkhead is hitting the nuts and stopping.
You can see the wear marks in this pic showing the flange seating between the cap and nuts.
I tried to use the new forum attachment feature but it rotates my pictures 90 degrees every time. Anyone know how to fix that issue too?
Thanks