jim miller
Well Known Member
In getting a 200 TT RV3 back flying again I have noted the large fiber-
glass spinner was never drilled for the front bulkhead plate. The rear is
drilled and has #8 nutplates. The front spinner bulkhead has been drilled
and has 4 holes with #8 nutplates but the spinner itself was never drilled.
If it has to be drilled any ideas on how? I am thinking about making
a 4 3/8 inch spacer block to simulate the prop's 4 3/8 " thickness but
small enough to drill around. Any ideas, comments welcomed.
Thanks
Jim Miller
glass spinner was never drilled for the front bulkhead plate. The rear is
drilled and has #8 nutplates. The front spinner bulkhead has been drilled
and has 4 holes with #8 nutplates but the spinner itself was never drilled.
If it has to be drilled any ideas on how? I am thinking about making
a 4 3/8 inch spacer block to simulate the prop's 4 3/8 " thickness but
small enough to drill around. Any ideas, comments welcomed.
Thanks
Jim Miller