From KAI Section 5.22:
"Install compression fittings to plastic tubing using the following steps:
Step 1: Drill #29 the inside of the tube."
I followed this directive and found the brass inserts fairly easy to insert to the plastic tube.
Step 4 implies that the insert should be difficult to install and probably requires putting the end of the plastic tube in boiling water to get the brass insert fully installed.
Am I making a mistake in drilling out the ends of the plastic tubing that will result in leaking brake fittings?
"Install compression fittings to plastic tubing using the following steps:
Step 1: Drill #29 the inside of the tube."
I followed this directive and found the brass inserts fairly easy to insert to the plastic tube.
Step 4 implies that the insert should be difficult to install and probably requires putting the end of the plastic tube in boiling water to get the brass insert fully installed.
Am I making a mistake in drilling out the ends of the plastic tubing that will result in leaking brake fittings?