Good afternoon and Happy New Year RVators
I have an electrical question regarding the installation of my GAP 26 regulator box. Referring to figure 5-6 on page 5-5 of the G3X installation manual. The schematic is showing the joining of two red power wires and two black ground wires. Then there is a single black wire and a single red wire running to power source. I plan to keep these connections in the wing close to the regulator box and then run a black and red wire to the fuselage. I’m just wondering about wire size. What guage should I use here? The installation is in a RV6A with a 14 volt system and my regulator box is installed mid wing.
Thank you for your time.
John Van Lieshout
RV6A 85%
I have an electrical question regarding the installation of my GAP 26 regulator box. Referring to figure 5-6 on page 5-5 of the G3X installation manual. The schematic is showing the joining of two red power wires and two black ground wires. Then there is a single black wire and a single red wire running to power source. I plan to keep these connections in the wing close to the regulator box and then run a black and red wire to the fuselage. I’m just wondering about wire size. What guage should I use here? The installation is in a RV6A with a 14 volt system and my regulator box is installed mid wing.
Thank you for your time.
John Van Lieshout
RV6A 85%