Bill.Peyton
Well Known Member
I am just finishing up painting our -10. I plan on painting the wings over the weekend, and I am debating on removing the screws holding the fuel tank in and leaving only a few on each side to hold the tank in place. I am soliciting ideas on what others have done.
Gathering from the posts over the last couple of years, it seems likely that the tanks will need to be removed at some time for a fuel leak (QB tanks), and I am trying to make it as painless as possible by planning ahead for the task.
If I could find some structural stainless screws I might even forgo painting the screw heads entirely.
Gathering from the posts over the last couple of years, it seems likely that the tanks will need to be removed at some time for a fuel leak (QB tanks), and I am trying to make it as painless as possible by planning ahead for the task.
If I could find some structural stainless screws I might even forgo painting the screw heads entirely.