Toobuilder
Well Known Member
Just installed a 335 using the little Garmin altitude encoder and the internal GPS. Though I can navigate to the altitude correction page and the field elevation is approximately right, when I go back to the main function page the altitude (flight level) display shows dashes. Based on the config page, it appears the encoder is talking to the transponder, but I must be missing something on some other configuration setting.
Ive run into this on my 327 and 330 transponders before, but always manged to fumble through the settings and get it to show up. Any thoughts from the brain trust?
Not sure that it makes any difference, but it is also wired to the non waas GNS430 in an attempt to retain the TIS info it had before.
Appreciate the help.
Ive run into this on my 327 and 330 transponders before, but always manged to fumble through the settings and get it to show up. Any thoughts from the brain trust?
Not sure that it makes any difference, but it is also wired to the non waas GNS430 in an attempt to retain the TIS info it had before.
Appreciate the help.