I have a few more updates of the build. Finished the step install with Cherry's. Van's cleared them and it was easier for me given the side panel was in on one side, oops. Had to weld up the PO holes as they were in the wrong location. Didn't get too anal about the plug welds, a little feather fill will most likely take care of the pits. If not then aluma lead will.
Flap actuator in. How much if any resistance should there be on this bad boy?
It isn't perfect but it is getting along nicely...Edit: I have realized that I have installed the rudder pedal frames in incorrectly...I had them in and out five times and just well just screwed it up lol!